Specs
Press Hydraulic specs
Setup notes and briefing numbers for Press Hydraulic.
Hydraulic press figures that matter
The Press Hydraulic specs page presents the key figures for hydraulic press selection. Buyers can review tonnage, stroke, daylight and other workshop requirements in one place.
Press selection starts with the job, not the paintwork. Check required tonnage, ram stroke, daylight opening and bed size against the material being formed, straightened or assembled. In Johannesburg workshops, buyers also need to note available three phase supply, access for rigging, and whether the press will handle plate, shafts or bush work.
Look at the frame, cylinder area and table arrangement before comparing numbers on paper. A quick inspection should include hose condition, oil leaks, gauge readability and whether the controls return properly after each stroke. That record is useful when a used press is being moved into service beside existing drilling, turning or boring equipment.
Key checks before buying
The useful specification sheet is the one that matches your actual pressing work. Capacity means little on its own if throat depth, table width or shut height do not suit the components coming through the shop. For repair and production work alike, note whether the machine is intended for pressing bearings, bending brackets, removing pins or valve related tasks.
Before widening the enquiry, match Press Hydraulic specs to the available space in your workshop and the heaviest item you plan to handle. Confirm motor details, pump condition, pressure setting range and any loose tooling that should travel with the machine.
- Tonnage suited to actual pressing work
- Stroke and daylight checked against components
- Control layout and gauge condition noted
Workshop conditions around Gauteng
Crown Mines buyers often have to judge a press against tight loading access, shared power capacity and mixed repair work. That is why bed height, overall machine footprint and mass matter alongside pressure figures. If the press is headed to a production line, include duty cycle and the type of tooling that will sit under the ram.
Dust inland can affect exposed slides, switchgear and oil cleanliness if covers are poor. Coastal sites may need closer attention to corrosion on polished rods, fasteners and electrical cabinets. During load shedding planning, it also helps to confirm restart procedure, motor protection and whether hydraulic pressure bleeds off when the unit stands idle.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
Hydraulic press capacity points
State the material type, maximum section size and the force you expect the press to deliver. Add whether the work is pressing in, pressing out, straightening, bending or assembly.
Useful notes include available headroom, door width for moving the machine, and any lifting equipment on site. If an older press is being replaced, mention what failed, what capacity it had, and which tooling must fit the new setup.
What our Metalworking Machine customers say
Verified Google reviews