Specs
Inspection Kit specs
Setup notes and briefing numbers for Inspection Kit.
Inspection points before machine sign-off
The Inspection Kit specs page lists the measurement and checking points linked to machine assessment. It helps buyers work through the important details in a practical order.
The checks used when an inspection kit is applied to a lathe, boring machine or valve grinding unit focus on measurable condition first, including bed wear, spindle play, slide movement and visible damage around guards, pumps and electrics. For Johannesburg workshop conditions, dust build-up and interrupted power supply are part of the assessment, not an afterthought.
Begin with the basic readings before anything is cleaned or adjusted. A straightedge, dial indicator, feeler gauges and test bar only help if the first condition is recorded as found. That gives a better picture of how the machine has actually been standing and working.
Readings and condition to record
The inspection kit spec should show which points are measured, the unit used, and where the reading was taken on the machine. Include spindle bearing noise, backlash on feed screws, tailstock alignment, lubrication flow and any missing loose items such as chucks, steadies or manuals. Buyers comparing used equipment need those notes far more than a general condition line.
Where a machine is being reviewed for sale or workshop use, tie the recorded checks to clear photos and the current machine tag.
- Bed wear measured near headstock
- Backlash noted on cross and top slide
- Photos matched to each check point
Workshop conditions affecting inspection
Machines viewed from Crown Mines often come from active engineering environments where swarf, old coolant and stored tooling can hide condition. Inspection notes should therefore separate dirt, neglect and true mechanical wear. Transport planning through Johannesburg also matters when loose accessories must be listed before collection.
Coastal stock may show surface corrosion on bright metal, while inland stock often shows dust packed into slides and control boxes. Load shedding can interrupt test runs, so the spec should state whether the machine was checked under power, by hand, or both. That distinction is important on feed systems, pumps and motors.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
Details to include with enquiry
State the machine type, the fault or concern, and which measurement points you need checked. If there is known movement, oil leakage or broken equipment, write that plainly with the photo set.
Compile a machine file for purchase review, workshop acceptance or resale prep. The most useful records usually combine inspection readings, accessory lists and a few close images of ways, screws, gears and electrical panels.
What our Metalworking Machine customers say
Verified Google reviews